Adam Equipment GBC Series User Manual page 18

SETTING OF PIN
• Display will show "F2" "Pin". This parameter allows setting of a new
password number. The default password is "0000".
• Press [Tare]. The "Weight" display will show "Pin 1".
• Enter the new password number. The "Unit Weight" display will show
dashes. Press [Tare].
• The "Weight" display will change to "Pin 2 ", Enter the password again
and press [Tare].
• The display will show "donE" to show the new password has been
accepted and will return to the menu. Record the new password in a
secured place.
• To exit a parameter, press the [Zero] key.
ENABLE WEIGHING UNITS
• Display will show "F3" "Unit". This parameter allows weighing units to be
enabled or disabled. If enabled the weighing units will change when the
[U.Wt./Unit] key is pressed. See section 6.0.
• To enter this function press the [Tare] key.
• The display will show the first weighing unit and if it is currently On or
Off. Press the [U.Wt./Unit] key to change the setting and then press
the [Tare] key to go to the next weighing unit. The weighing units
selected will depend upon the model and the capacity of the scales.
See Section 12.2, Service Parameters.
• Press the [Zero] key to return to the weighing mode.
P a g e 16 © Adam Equipment Company 2011