Advertisement
Forms Setup
allows you to
set print
parameters
for each of
the 10 form
templates 0-9.
Defines Each Form's Configuration
Functions
Possible Values
Form #:
0 through 9
F# Path:
Front, Center, or Rear
F# Auto Cut:
Yes or No*
F# CPI:
10*, 12, 13.3, 15,
16.74, 17.14, or 20
F# Left Mar:
0* through 134
F# Right Mar:
1 through 255, or MAX*
F# LPI:
6* or 8
F# Length:
1 through 227 (66*)
F# Top Mar:
0* through 255
F# Btm Mar:
0* through 255
F# Scroll+:
0* through 127
F# Cut Adj:
-85 to +84, 0*, or Auto
F# Print Adj:
-128 through 0*, or 0
F# Font:
FX FD, FX DF, FX LQ PC FD,
PC DF, PC LQ EB FD, EB DF,
EB LQ, LA120FD, LA120DF,
LA120LQ, OCRA OQ, OCRB
OQ PCL2 FD, PCL2 DF PCL2 LQ
F# Draft:
Normal* or Fast
F# Impact:
Norm* or High
F# Lang:
USA*, France, Germany,
England, Denmark, Sweden,
Italy, Spain, or Japan
F# Zero:
Normal* or Slashed
F# Unidir:
Yes or No*
F# (F0 - F9) = indicates which form is being configured
Description
Allows you to select the desired form to be
configured. Printer defaults to the currently
selected form.
Assigns tractor path to be used for current form
( Available on FormsPro 4503 only ).
Available only when the optional FormsCutter
is installed. Will cut every form printed.
Sets character pitch in characters-per-inch.
Sets left margin in columns (characters) from
left-most print position. Column width based
on CPI. Left margin must be less than right margin.
Sets right margin in columns (characters)
from left-most print position. A value of MAX
sets margin to the rightmost print position.
Sets line pitch to 6 or 8 lines-per-inch.
Sets form length in lines at current line pitch.
Sets top margin by adding specified number
of lines to top of form.
Sets bottom margin in lines from bottom of form.
Sets distance in lines from top margin to first
print line of form
( Note: does not add lines to form
as top margin does ).
Use Scroll with existing
software to take advantage of zero-waste
capability. If first line is printed too high on paper
after aligning edge with tear bar, use Scroll to
position it lower on page. Scroll does not modify
top of form position Not recommended for use.
in place of Top Margin.
Available only when optional FormsCutter is
installed.
Sets print position in 72nds (.01388") of an inch
from top of form. May be used to align vertical
print position to match a preprinted form
which does not begin at an even number of
lines from the top edge of paper.
Selects font to be used. ( Note: Fonts not
installed will not be displayed ).
Selects the mode or quality of printing, either
"Normal" or "Fast".
Sets character printing mode to normal or
high impact.
Sets character substitution table for alternate
language ( Note: Epson font must be selected for
character substitution).
Sets type of zero to be printed.
Sets uni-directional printing instead of
bi-directional printing.
*Factory Default Setting
2
FORMS
Advertisement
