Forms Setup - Printek FormsPro 4300 Quick Reference Manual

FormsPro

Forms Setup

allows you to
set print
parameters for
each of the 10
form templates
0 - 9
4000se Series
Defines Each Form's Configuration
Functions
Possible Values
Form # or Name: 0 - 9, A - Z, or spaces
Name Path: Front, Center, Rear
Auto Cut: Yes or No*
Cut Adj: minus 85 to + 84, 0*, or Auto
LPI: 6*, 8
Length: 1 through 227 (66*)
Top Mar: 0* through 226
Bottom Mar: 0* through 226
Character Per Inch: 10*, 12, 13.3, 15, 16.74, 17.14, or 20
Left Mar: 0* through 268
Right Mar: 4 through 272*
Font: Epson FX FD*, DF, LQ
PC English FD, DF, LQ
PC Latin 2 FD, DF, LQ
DEC LA 120/210 FD, DF, LQ
EBCDIC FD, DF, LQ
OCRA-A OQ
OCR-B OQ
Roman-8 FD, DF, LQ
ML Euro (858) FD, DF, LQ
ML (850) FD, DF, LQ
Draft: Normal* or Fast
Impact: Normal* or High
Lang: USA*, France, Germany, England,
Denmark, Sweden, Italy, Spain,
Japan, or Finland
Zero: Normal* or Slashed
Unidir: Yes or No*
FORMS
Description
Allows you to select the desired form to be configured.
Printer defaults to the currently selected form.
Assigns tractor path to be used for current form (A vailable
on FormsPro 4503se only).
Available only when the optional FormsCutter is installed.
Will cut every form printed.
Available only when optional FormsCutter is installed.
Sets line pitch to 6 or 8 lines-per-inch.
Sets form length in lines at current line pitch.
Sets top margin by adding specified number of lines t o top
of form.
Sets bottom margin in lines from bott om of form.
Sets character pitch in characters-per-inch.
Sets left margin in columns (characters ) from left-most print
position. Column width based on CPI. Left margin mus t be
less than right margin.
Sets right margin in columns (characters) f rom the left-most
position. A value of 272* sets margin to the right-m ost
position.
Selects font to be used. (NOTE: Fonts not inst alled will not
be displayed).
Selects the mode or quality of printing, either "Norm al" or
"Fast".
Set Character printing mode to normal or high impact.
Sets character substitution table for alternate l anguage.
(NOTE: Epson font must be selected for charact er
substitution).
Sets type of zero to be printed.
Sets uni-directional printing instead of bi-directional pri nting.
*Factory Default Setting
2