Forms Setup - Printek FormsMaster 8000se Setup Manual

FormsMaster

Forms Setup

allows you to
set print
parameters for
each of the 10
form templates
0 - 9
8000se Series
Defines Each Form's Configuration
Functions
Possible Values
Form # or Name: 0 - 9, A - Z, or spaces
Name Path: Front, Center, Rear, Center+Rear,
Front+Center+Rear
Auto. Cut: Yes or No*
Cut Adj: Auto, -0.2951"...0*...+0.2951", Auto
LPI: 6*, 8
Length: 1 through 227 (66*)
Top Mar: 0* through 226
Bottom Mar: 0* through 226
Characters Per Inch: 10*, 12, 13.3, 15, 16.74, 17.14, or 20
Left Mar: 0* through 268
Right Mar: 4 through 272*
Font: Epson FX FD*, DF, LQ
PC English FD, DF, LQ
PC Latin 2 FD, DF, LQ
DEC LA 120/210 FD, DF, LQ
EBCDIC FD, DF, LQ
OCRA-A OQ
OCR-B OQ
Roman-8 FD, DF, LQ
ML Euro (858) FD, DF, LQ
ML (850) FD, DF, LQ
Draft: Normal* or Fast
Impact: Normal* or High
Lang: USA*, France, Germany, England,
Denmark, Sweden, Italy, Spain,
Japan, or Finland
Zero: Normal* or Slashed
Unidir: Yes or No*
FORMS
Description
Allows you to select the desired form to be configured.
Printer defaults to the currently selected form .
Assigns tractor path to be used for current form (Available
on FormsMaster 8003se only).
Available only when the optional FormsCutter is installed.
Will cut every form printed.
Available only when the optional FormsCutter is installed.
Sets line pitch to 6 or 8 lines-per-inch.
Sets form length in lines at current line pitc h.
Sets top margin by adding specified number of lines t o top
of form.
Sets bottom margin in lines from bot tom of form.
Sets character pitch in characters-per-inch.
Sets left margin in columns (charact ers) from left-most print
position. Column width based on CPI. Left margin m ust be
less than right margin.
Sets right margin in columns (characters ) from the left-most
position. A value of 272* sets margin to the right-m ost
position.
Selects font to be used. (NOTE: Fonts not ins talled will not
be displayed).
Selects the mode or quality of printing, either "Norm al" or
"Fast".
Set Character printing mode to normal or high impact .
Sets character substitution table for alternat e language.
(NOTE: Epson font must be selected for charac ter
substitution).
Sets type of zero to be printed.
Sets uni-directional printing instead of bi-directional printing.
*Factory Default Setting
2