Advertisement
Options
Set-Up
allows you
to set
operating
variables
and install
optional
products.
Configures Options
Functions
Possible Values
Max Form #:
0 through 9
Ribbon Check:
On* or Off
Ribbon Life:
23*, 5 through 30
Paper Cutter:
Yes or No*
Imager:
Yes or No*
Translation:
Off* or On
Free Format:
Off* or On
Terminator:
LF* or CR
Ignore Char:
Off* or On
Zero:
Normal or Slashed*
Ignore Col. 1:
Yes or No*
*
~
Control Char:
^
;
Bar Codes:
Hi-Res*, Med-Res,
Line Reg:
Off or On*
To access these menus, take printer offline and hold down the Set-Up button.
Setup: Forms
(One Beep)
Description
Sets the last form number to be displayed by
operator selection with FORM SELECT button
or while in "Setup: FORMS" menu.
Sets whether ribbon checking is active.
Turning off may limit the warranty on print
head. For more information, see "Using
Special Features" in User Manual and refer to
warranty in "Printer Specifications" appendix.
Sets number of characters to be printed before
"Change Ribbon" message is displayed. For more
information, see "Using Special Features" in User
Manual.
Sets whether optional FormsCutter is installed.
Sets whether Imager or Imager Plus is installed.
If Imager option is installed, refer to Imager Manual.
If Imager option is installed, refer to Imager Manual.
If Imager option is installed, refer to Imager Manual.
If Imager option is installed, refer to Imager Manual.
If Imager option is installed, refer to Imager Manual.
If Imager option is installed, refer to Imager Manual.
!
?
If Imager option is installed, refer to Imager Manual.
\
|
'
If Imager option is installed, refer to Imager Manual.
If Imager option is installed, refer to Imager Manual.
Setup: Interface
(Two Beeps)
4
OPTIONS
*Factory Default Setting
Setup: Options
(Three Beeps)
Advertisement
