Saeco RUBINO 200 Operation And Maintenance page 44

English
- Instant product:
It defines the quantity of instant product to be
dispensed.
BEVANDA
Example:
SOLUBILE 3:
'005' indicates that 5 units of instant product 3
will be used.
The quantity of instant product can be adjusted
from '0' to '250' with steps of 1.
- Instant water:
It defines the amount of water to be mixed with
powder instant product.
BEVANDA
Example:
ACQUA SOL.3:
'3' indicates that water will be mixed with instant
product 3. '022' indicates that 22 units of water
will be brewed with the instant product.
The amount of water can be adjusted from '0' to
'500' with steps of 2.
Coffee beans C
Important
In case the sequence includes more instant
products, the sequence 'INSTANT - WATER' will
appear again.
If parameter programming concerning the
instant product ('INSTANT - WATER') is such to
extend powder brewing beyond water brewing,
the vending machine stops powder dosing as to
avoid an insufficient mixer rinsing and emits a
beep. Check again the parameters set, in order
to obtain a correct dispensing. Powder
dispensing must end a few instants before the
water dispensing so as to allow a good mixer
rinsing.
44
For more information visit www.Gumball.com | 800-260-0010 | +1-214-550-5079
A
005
A
022
- % Soluble
This defines the speed at which the instant
powder and water are brewed (see chart).
Brewing speed of instant powder and hot water
is adjustable from "10" to "120" in steps of 10.
By setting a value of "10", the pump works at the
maximum capacity, while the instant product is
brewed with impulses at minimum capacity.
By setting "100", both the instant product and
water will be brewed at maximum capacity.
By setting "120" the pump works with impulses
at minimum capacity, while the instant product
is brewed at maximum capacity.
Soluble
speed
MAX
MIN
10
Speed
pump
MAX
MIN
10
If pre-ground coffee is used, the %instant product
item defines only the speed with which water is
dispensed in the group, since the adjustment of
the ground coffee brewing into the brewing cup
has no effect on the end product.
The relationship between the water pump
adjustment and the %instant product item is
described in the table below:
% INSTANT PRODUCT
100
110
120
100 120
% Soluble
100 120
% Solubile
BREWING TYPE
Pump at 100%
Pump adjusted at 90%
Pump adjusted at 80%