Saeco RUBINO 200 Operation And Maintenance page 41

- Protocol
It enables the selection of the protocol used by
the vending machine to dialogue with the
payment system installed on it:
- EXECUTIVE Protocol;
- PRICE HOLDING (ECS) Protocol;
- BDV Protocol;
- MBD Protocol;
- NO PROTOCOL (no serial protocol);
- MDB SLAVE (the vending machine
operates as slave to another vending
machine);
- Master / Slave executive (the vending
machine operates as master for
another vending machine).
- PDH Master / Slave (the vending machine
operates as master for another vending
machine) .
The NO PROTOCOL setting shall be used
when the VM is not equipped with a payment
system operating with one of the protocols
provided in the other settings: EXECUTIVE,
PRICE HOLDING, BDV, MBD or MDB SLAVE.
This setting is necessary since the VM
continuously checks for dialogue with the
provided payment system. If the VM detects no
dialogue, it signals this fault on the display
through the message "NO LINK". This signal
cannot be considered an error condition.
- MDB settings
It enables access to particular functions of the
MDB protocol.
• Recharge
It allows disabling or enabling the possibility of
performing any MDB card recharge operation.
By setting RECHARGE = NO the vending
machine will only deduct the cost from MDB
cards.
• Max card charge
It enables to set the maximum credit level,
beyond which all recharge operations (if enabled)
are ineffective. By setting MAX RECHARGE =
20.00, the credit on the vending machine will be
transferred to the card if the sum of the credit on
the vending machine and on the card does not
exceed 20.00.
• Reject card
It enables to set the maximum credit level,
beyond which the card is rejected by the system.
For more information visit www.Gumball.com | 800-260-0010 | +1-214-550-5079
By setting REJECT CARD = 25.00, the vending
machine will reject all cards with a credit which
exceeds this amount. If this card is detected,
the display will not show the credit but a " ——"
message will be displayed and no sale will be
carried out.
• Card prices
This function enables the application of
differentiated prices if the card is used for
payment. By setting CARD PRICES = YES a
new menu entry will appear in PRICE
MANAGEMENT, enabling setting the price level
to be applied to the product (beverage or snack)
if payment is made by card.
• Enable coins
It enables the selection of which coins will be
accepted by the change-giving coiner. By setting
'Y' a specific coin will be accepted. On the
contrary, the 'N' setting prevents the change-
giving coiner from accepting a particular coin.
Coins beneath the vending machine scale factor
are always disabled and display the 'N' setting.
• Alt. payout
It enables / disables the use of Alternative Payout
for the level 3 MDB change-giving coiner. By
setting Yes, the change-giving coiner is called
on to dispense change. Change is limited to 255
times the scaling factor of the change-giving
coiner (typically 12.75 for the Euro area - with
scaling factor of 5). By setting No, change is
given by exploiting the vending machine's
algorithm. Max. change is 60000 units (typically
600 for the Euro area).
• Maximum change
It enables setting of the maximum change which
can be dispensed by the change-giving coiner.
Default = 10.00.
• Exact change policy
In MDB change-giving coiners, the condition of
no change available can be selected within the
following table:
Key:
L = channel with the lowest coin value below
the minimum level
M = channel with the medium-low coin value
below the minimum level
HL = channel with the medium-high coin value
below the minimum level
HH = channel with the highest coin value below
the minimum level
English
41