Epson Expression 1600 Setup Manual page 2

Quick ceph systems

Hide thumbs Also See for Expression 1600:

Epson Expression 1600 Scanner Setup

Once the software for the Epson Expression 1600 has been installed, you can begin scanning x-rays.

The following section covers the recommended settings for Quick Ceph Image Pro and Quick Ceph 2000.

Setting up the Scanner Interface

Lateral X-ray Orientation

NOTE: For correct orientation, patient identification on the x-rays

Place the x-ray on the scanner bed as shown

above. Close the lid and double click on the

Photoshop alias, as shown below.

Change settings to match those with the arrows.

At this point, both the "Source" and "Target" set-

tings are inaccessible.

http://www.quickceph.com/docs/1030Expression_Setup.pdf

Panoramic X-ray Orientation

should face the scanner bed.

The scanner soft-

ware will launch.

Click on the File

menu and scroll

down to Import.

Then, select Twain

Acquire. The

scanner settings

will appear.

Selct this setting to activate the

Transparency Adapter

Change to 8-bit Gray

Select or type in the resolution required for your specific

program:

Quick Ceph Image Pro: 72 dpi Quick Ceph 2000: 144 dpi

Change to pixels

Make sure this value is always 100%

Click on the Preview button when the changes have been

made. Once the image has been previewed, you will be able

to change the Source and Target settings.

Page 2

Quick Ceph

Systems

Doc ID# 1030Expression_Setup - Revision 12-1-00