Stick Welding; Hf Tig & Lift Tig Welding - Thermal Arc 160 TS ARCMASTER Service Manual

ARCMASTER 160TS

6.01 Stick Welding

Connect work lead to negative terminal
Connect electrode lead to positive terminal
Switch machine on
Set weld current
Connect remote control device if required
Use the Scroll Buttons to move to the parameter
that needs to be set. The LED will show which
function is being adjusted on the weld sequence
graph. Use the control knob to adjust each
parameter.
Set HOT START
WELD
Set current
Commence welding
HF TIG & Lift TIG Welding
6.02
Connect work lead to positive terminal
Connect TIG torch to negative terminal
Switch machine on
WELD
Set current.
Connect remote control device. A remote
control device is required for use during LIFT
TIG and HF TIG operation. See section 4.1,
Remote Control Socket
section 2 "
complete details of the remote device.
Use the Scroll Buttons to move to the parameter
to be set. The LED will show which function is
being adjusted on the weld sequence graph. Use
the control knob to adjust each parameter.
PRE-FLOW
Set
HOT START
Set
POST-FLOW
Set
WELD
Set
POST-FLOW
Set
Slope Mode Parameters if required
INTIAL CUR
Set
UP SLOPE
Set
Set (WELD)
BASE
Set
DOWN SLOPE
Set
CRATER CUR
Set
Pulse Mode parameters if required
Set PULSE WIDTH % for PEAK CURRENT
Set PEAK CURRENT
Set PULSE FREQ
Commence welding
", for
33
time
current
time
current
time
current
time
PEAK CUR
current
current
time
current