Drobo storage system User Manual page 28

Disconnecting Your Drobo from DroboShare
Before disconnecting Drobo from DroboShare or disconnecting power from Drobo or DroboShare, always put Drobo into
Standby first. You can do this by clicking on the appropriate Standby button on the Tools Tab of the Advanced Control
Panel. Clicking on the Standby button in the Commands section will put a single Drobo into Standby. Clicking on the
Standby button in the DroboShare section will put any Drobo connected to DroboShare into Standby.
Warning: Failure to properly remove Drobo from DroboShare can cause loss of data.
The Standby operation should take only a few seconds. Once Drobo is in Standby, all lights will turn off except for the
power indicator, which will turn orange. Only then, can you safely disconnect your Drobo from DroboShare or disconnect
the power from your Drobo.
Related Topics
Disconnecting Your Drobo from Your PC
28