[Max. Density Adjustment] - Konica Minolta bizhub36 Users Manual Network Administration

4.10 [Maintenance Menu]

[Max. Density Adjustment]

This function is useful when the required printing result is not obtained, for example, the printing density is
too high or too low. Scan the amount of toner adhered on an output test pattern, and adjust to the optimal
density.
0 Before correcting the maximum density, fine-adjust the printing density (amount of toner) using [Max.
Image Density Adj].
0 After correcting the maximum density, be sure to also correct the gradation.
0 If the required printing density result is not obtained even after the maximum density has been correct-
ed, contact your service representative.
1
Press the Utility/Counter key ö [Admin Settings] ö [Maintenance Menu] ö [Printer Adjustment] ö
[Gradation Adjustment].
2
Press [Max. Density Adjustment].
3
Press [Print].
4
Press [OK].
5
Two test pattern are printed.
6
Press [Scan].
7
Place the first printed test pattern on the Touch Panel in the orientation displayed in the Original Glass.
8
Place 10 or more sheets of blank paper on top of the test pattern to prevent it from becoming transpar-
ent.
9
Close the ADF.
10
Press the Start key.
The test pattern is scanned.
11
Place the second printed test pattern on the Touch Panel in the orientation displayed in the Original
Glass.
12
Place 10 or more sheets of blank paper on top of the test pattern to prevent it from becoming transpar-
ent.
13
Close the ADF.
14
Press the Start key.
The test pattern is scanned.
bizhub 42/36
4
4-31