Extron electronics VSW 2VGA A User Manual page 18

2-input, 1-output vga and audio switcher
Hide thumbs Also See for VSW 2VGA A:
Table of Contents

Advertisement

Installation and Operation, cont'd
Figure 2-16 is an example showing ten daisy chained
VSW 2VGA A switchers. In the example, the output of the first
switcher in the chain (
switcher in the daisy chain (
switcher. Additional switchers in the chain output to Input 2 of
the previous switcher.
Daisy chaining requires the setting of jumpers. The three
jumper tables in figure 2-16 indicate how the jumpers must be
set. Note that Table 1 is assigned to switchers
Table 2 is assigned to switchers
Table 3 is assigned to switchers
N
Up to ten switchers can be daisy chained without any
degradation in picture quality. One 12 VDC power supply
is required for every group of five daisy chained switchers.
The power supply must be connected to the middle
switcher in a group of up to five switchers. In the example,
the power supplies are connected to switchers
N
The installer should label each switcher in numerical order
so that its position in a daisy chain can be readily identified
at a future date.
In the example, the VSW I AAP interfaces output to
Input 1 of its attached switcher. Press the VSW I AAP's
Input select (Show Me) button to route the interface's
input to the projector.
Daisy chaining audio signals is similar to daisy chaining
N
video signals. In figure 2-16, audio is output from the
VSW I AAP to the switcher's Input 1 audio input. The
switcher's audio output is then input to the Input 2 audio
input of the next switcher in the daisy chain.
N
The "show me" feature can be used without a VSW I AAP
control panel. Select input 1 using either the front panel
toggle switch (see item
the rear panel contact closure control (see item
Panel Features") to issue the show me control signal.
N
Daisy chaining uses all pins and wires of a standard VGA
cable. Not all VGA cables include all pins and wires.
ensure that the VGA cable that you use has all 15 pins
connected.
VSW 2VGA A • Installation and Operation
2-18
a
) is routed to a projector. The second
b
) outputs to Input 2 of the first
a
f
and
;
b
c
d
g
h
i
,
,
,
,
, and
; and
e
j
and
.
c
and
c
in "Front Panel Features") or
e
in "Rear
h
.
VSW 2VGA A • Installation and Operation
2-19

Advertisement

Table of Contents
loading

Table of Contents