Troubleshooting Tables; Appendix C - Sunwave Tech. SRC-7000 User Manual

SRC-7000 User's Manual

Appendix C

Troubleshooting Tables

Problem
LCD does not show
anything when you touch it
The SRC-7000 doesn't
operate a device.
You cannot operate a
device even after teaching
the device using the
learning function.
You see an "error" display
on the LCD screen during
the learning procedure.
You see an "error" display
during operation.
IR LEARNING is not
successful.
70
•
Batteries may be dead.
•
Replace the batteries with three new AAA Alkaline batteries.
•
Check the batteries are properly installed.
•
Make sure that the desired device on the SRC-7000 LCD panel
has been selected.
•
Move closer to the device. The maximum operating distance
is approximately 10 meters (30 feet).
•
Ensure that you are aiming the SRC-7000 directly at the device
and that there are no obstructions between the SRC-7000 and
the device.
•
Ensure that you have correctly used the learning function to
configure the device or the Pre-Programmed Code has been
properly done.
•
Re-teach the malfunction key.
•
Make sure that your SRC-7000 has correctly learning the target
device's remote control code.
•
Delete the device data from the SRC-7000 and carry out the
learning function again.
•
Make sure you did not program more than one remote for a
given device.
•
Make sure you hold the target remote's key till the screen
displays OK or Error on the screen.
•
Make sure the two remotes are not too close or too far apart –
keep them about 2~4 inches (5~10 cm) apart, and your device
remote control is aiming directly at the SRC-7000's learning
eye.
•
The key that you pressed has not been taught.
•
Teach the key using the learning procedure.
•
Replace batteries in the SRC-7000 and the remote you are
trying to configure.
•
Keep the distance between the remote control and the
SRC-7000's learning eye to about 2~4 inches.
•
Do not use the learn function near an incandescent lamp.
•
Memory capacity is full (56 keys for each of eight models).
•
The learning process has no errors, but you still can't control
your AV devices:
Repeat the learning procedure again.
-
Solution