Appendix C - Troubleshooting; Troubleshooting Tables - Sunwave Tech. SRC-3810 User Manual

Appendix C – Troubleshooting

Troubleshooting Tables

Problem
LCD does not show
anything when you touch
it or press the hardware
buttons.
The SRC-3810 doesn't
operate a device.
You cannot operate a
device even after
teaching the device using
the learning function.
49
Solution
Batteries may be dead. Replace the
batteries with 4 new AAA Alkaline
Batteries (page 4). Check that the
batteries are properly installed.
Make sure that the desired device
screen on the SRC-3810 LCD panel
has been selected.
Move closer to the device. The
maximum operating distance is
approximately 30 feet.
Ensure that you are aiming the SRC-
3810 directly at the device and that
there are no obstructions between
the SRC-3810 and the device.
Ensure programming with the
learning function (page 18) or using
the manufacturer codes (page 16)
has been properly done. Re-teach
the button.
Make sure that your SRC 3810 has
correctly "learned" device's remote
control code. (page 19).
Delete the device data from the
SRC-3810 and carry out the learning
function again (page 18).
Make sure you did not program
more than one remote for a given
device.