Device Setting - Sunwave Tech. SRC-7000 User Manual

SRC-7000 User's Manual

2.3 Device setting

1. Turn on the targeted device for SRC-7000 to setting the device.
2. SRC-7000 will directly get throw the setup mode when you operate
the SRC-7000 at first time. Please tap the target device key in the
Main Menu to enter "Setup device" menu. (ex. "TV" device)
* Pre-code: load pre-programmed IR code from the factory
3. Pressing the
press
4. Choose the first letter of targeted device brand (ex.
behalf of Sony, Samsung...etc ), and point the SRC-7000 at
the targeted device, and then tap
auto searching.
5. As you see the targeted device has been turned off, please tap
or press any buttons to stop auto searching right away. Tap
(code number as shown in the top middle position) till the
targeted device has been turned on again. Press the power
key to test the code to confirm the code.
6. Finally, press
18
default (no guarantee being able to control all brand
devices).
or
button for entering the operation mode.
or gently to figure out the correct remote code
button to load the code and exit.
buttons to choose "Yes" item and
soft button to start
"S" on