Com1 Connector (Io Area) - Kontron KTQ67/Flex User Manual

KTD-N0829-D

5.5 COM1 Connector (IO Area)

Four RS232 serial ports are available on the KTQ67, COM1 is available in the IO Area while the other
COM ports are available on internal pin header connectors.
The typical definition of the signals in the COM ports is as follows:
Signal Description
TxD Transmitted Data, sends data to the communications link. The signal is set to the marking
state (-12V) on hardware reset when the transmitter is empty or when loop mode operation is
initiated.
RxD Received Data, receives data from the communications link.
DTR Data Terminal Ready, indicates to the modem etc. that the on-board UART is ready to
establish a communication link.
DSR Data Set Ready, indicates that the modem etc. is ready to establish a communications link.
RTS Request To Send, indicates to the modem etc. that the on-board UART is ready to exchange
data.
CTS Clear To Send, indicates that the modem or data set is ready to exchange data.
DCD Data Carrier Detect, indicates that the modem or data set has detected the data carrier.
RI Ring Indicator, indicates that the modem has received a ringing signal from the telephone line.
The pinout of Serial ports COM1 is as follows:
Pull
Note
U/D
-
-
-
/5K
/5K
Page 34
Ioh/Iol Type Signal PIN Signal Type Ioh/Iol
- PWR GND 5
O DTR 4
O TxD 3
- I RxD 2
- I DCD 1
IO-Area Connectors
9 RI I -
8 CTS I -
7 RTS O
6 DSR I -
KTQ67 Users Guide
Pull
Note
U/D
/5K
/5K
-
/5K