Factory Defaults - Allied Telesis AT-9108 Installation Manual

Factory Defaults

Factory Defaults
1-12
Table 1-5 shows factory defaults for the all switch models.
Item
Port status
Serial or Telnet user
account
Console port configuration
Web network management
SNMP read community
string
SNMP write community
string
RMON history session
RMON alarms
BootP
QoS
802.1p priority
802.3x flow control
Virtual LANs
802.1Q tagging
Spanning Tree Protocol
IP Routing
Forwarding database aging
period
RIP
OSPF
IP multicast routing
DVMRP
IGMP snooping
GVRP
Table 1-5 Switch Factory Defaults
Default Setting
Enabled on all ports
admin with no password and user with no password
9600 baud, eight data bits, one stop bit, no parity, XON/XOFF
flow control enabled
Enabled
Public
Private
Enabled
Disabled
Enabled on the default VLAN (default)
All traffic is part of the default queue.
Recognition enabled
Enabled
One VLAN named default; all ports belong to the default VLAN.
The default VLAN belongs to the STPD named s0.
All packets are untagged on the default VLAN (default).
Disabled; one STPD (s0)
Disabled
300 seconds (5 minutes)
Disabled for the switch; enabled on each VLAN configured with
an IP address.
Disabled for the switch; enabled on each VLAN configured with
an IP address. All VLANs belong to the backbone area.
Disabled
Disabled for the switch; enabled on each VLAN configured with
an IP address.
Disabled for the switch; enabled on each VLAN configured with
an IP address.
Disabled