Page 1
South Korea Te l: +82 (31) 719-8033 Fax: +82 (31) 719-8032 www.opticis.com For order support, please contact your Distributor or Reseller. For technical support, check with the Opticis web site www.opticis.com or contact techsupp@opticis.com. Doc No. : OKM-D140704-KVMX-200 / Rev1.0...
Figure 1 – Connection Diagram of them. It makes the installation of KVMX-200-TR more easy and flexile at any Figure 2 – Connection of Transmitter variable resolutions.
System Requirements for Setup Installation Important: Please keep the installation procedure below. Improper or no Hardware requirements operation may result if the start-up sequence is not correctly followed. You have a graphic controller card with a DVI port in your Step 1 Carefully unpack the contents of the shipping group.
PC at Local side. On the contrary, if you set the switch from the Local to the Remote, the Note2: KVMX-200-TR reads EDID information of both local side and remote side Remote status LED (Red) of LSKP-1003 and (Green) of RSKP-1003 will be displays and then, determines the lowest resolution of them for easy and flexible turned on, and you can control a PC at Remote side.
- Ensure that all plugs and jacks used by external power supplies (both One (1) or Two (2) LC connector Connectors 1310/1550 nm Opticis and others) are firmly connected. Ensure that the related LED ON. Wavelength Up to 1.0 km (3,280feet) over LC single-mode Operating Distance...
KVMX-202-TR: Two (2) multi-mode fibers connection by SFP module Note: Opticis recommend user to use the SFP module, supplied by Optics for stable connection. If user uses other SFP modules, it might cause malfunction or failure to properly use the product.
Step 1 “Next” button. Please download the setup and firmware file. Note: Opticis will provide the setup and firmware file, if the KVMX-200-TR program needs to be updated. Step 2 Click “Setup” file in DN_GUI folder and select a language. Then, start setup wizard is shown as below.
Opticis or its authorized resellers. If a product does not work as warranted during the applicable warranty period, Opticis shall, at its option and expense, repair the defective product or part, deliver to customer an equivalent product or part to replace the defective item, or refund to customer the purchase price paid for the defective product.
Regulatory Statements This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 and 2 of FCC Rules, EN 55022/55024/61000-3 for CE certification.