Table of Contents
Advertisement
DSA-3110 Hotspot Edition – User Manual
Configuring Static Interface
For eth0 (LAN1) and eth1 (LAN2) interfaces, this interface type is the only available type. For eth2
(WAN1) and eth3 (WAN2) interfaces, both Static and DHCP types are available.
Picture 10. Configuring a static IP address for LAN1 interface.
You can modify the following fields:
IP address The IP address assigned to the interface.
Mask The subnet mask.
MTU The maximum transmission unit in the interface. Optional.
MAC-address The hardware address to be set for the interface Optional.
Metric The metric of the interface. Allows assigning a priority for the interface. The
Default gateway The IP address of the default gateway. Sets the address for routing packets to
Start Select a radio button to enable or disable the interface auto-start upon the
Click the Save button.
lower the value, the higher is the interface priority. Optional.
external networks. Applicable for the WAN interfaces only. Optional.
load of the device.
Page 15 of 61
Advertisement
Table of Contents
