Table of Contents
Advertisement
DSA-3110 Hotspot Edition – User Manual
Network Address Translation
Proceed to the Address translation page to configure the NAT (Network Address Translation)
function.
This page is used to declare subnets which require address translation. A physical interface used for
translating a network is selected automatically on the basis of network settings configured on the
Net > Network interfaces page.
The Off button is used to completely disable the NAT function in the device.
The Factory button is used to restore the default setting of the NAT function.
By default, the NAT function is enabled for the following networks: 192.168.1.0/24,
192.168.0.0/24, 10.0.0.0/8.
To modify the NAT settings, do the following:
Open the Net > Address translation page.
•
Click the Edit button.
•
Enter the slash-separated pair of the subnet and subnet mask. The subnet mask can be
•
entered in the common (4-octet) format (e.g., 255.255.255.0) or in so called variable-length
subnet mask (VLSM) format (e.g., /16 corresponds to 255.255.0.0, /24 – to 255.255.255.0, /
30 – to 255.255.255.252, etc.).
Click the Save button.
•
Picture 23. The Net > Address translation page.
Page 24 of 61
Advertisement
Table of Contents
