Table of Contents
Advertisement
DSA-3110 Hotspot Edition – User Manual
Attention!
1. To keep the device settings in the non-volatile memory, you should save the changes on the
System > Configuration page (click the Save button).
2. The factory default settings can be restored via the web-based interface (System >
Configuration > Factory) or via the hardware Reset button. The hole of the button is
located on the back panel of the device next to the power connector. Use a small paperclip
to activate the button; insert it into the hole (with the device turned on), push, and hold for
10 seconds. If you act properly, first the Status LED turns off for 2 or 3 seconds, and then
the LED blinks fast for some seconds, which means the device is restoring the default
settings. After that the LED turns off for 2 or 3 seconds again, and then the device is
completely reset.
Picture 7. The same page in Russian.
Page 12 of 61
Advertisement
Table of Contents
