19-Inch Rack Mounting; Figure 2-14: Mp-124 With Brackets For Rack Installation - AudioCodes MediaPack MP-11x Series Installation Manual

Hide thumbs Also See for MediaPack MP-11x Series:
Table of Contents

Advertisement

Installation Manual
2.2.3.2

19-inch Rack Mounting

The MP-124 can be installed in a standard 19-inch rack, by using two short, equal-length
brackets (supplied). The MP-124 with attached brackets for rack installation is shown in the
figure below:

Figure 2-14: MP-124 with Brackets for Rack Installation

When installing the chassis in a rack, implement the following safety
instructions:
To install the MP-124 in a 19-inch rack, take these 7 steps:
1.
Remove the two screws located on one side of the MP-124 (nearest the front panel).
2.
Insert the peg on one of the brackets into the third air vent down on the column of air
vents nearest the front panel.
Version 5.6
Rack Mount Safety Instructions
Elevated Operating Ambient - If installed in a closed or multi-unit rack
assembly, the operating ambient temperature of the rack environment
may be greater than room ambient. Therefore, consideration should be
given to installing the equipment in an environment compatible with the
maximum ambient temperature (Tma) of 40°C (104°F).
Reduced Air Flow - Installation of the equipment in a rack should be
such that the amount of air flow required for safe operation on the
equipment is not compromised.
Mechanical Loading - Mounting of the equipment in the rack should be
such that a hazardous condition is not achieved due to uneven
mechanical loading.
Circuit Overloading - Consideration should be given to the connection
of the equipment to the supply circuit and the effect that overloading of
the circuits might have on overcurrent protection and supply wiring.
Appropriate consideration of equipment nameplate ratings should be
used when addressing this concern.
Reliable Earthing - Reliable earthing of rack-mounted equipment should
be maintained. Particular attention should be given to supply connections
other than direct connections to the branch circuit (e.g., use of power
strips.)
21
2. Installing the Device
November 2008

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents