Connecting Mp-124 Rs-232 Port To A Pc; Connecting Mp-124 To Power; Figure 2-20: Mp-124 Rs-232 Connector Pinouts - AudioCodes MediaPack MP-11x Series Installation Manual

Installation Manual
2.2.4.4

Connecting MP-124 RS-232 Port to a PC

Follow the procedure below to connect the MP-124 serial (RS-232) interface to a PC using
a standard, straight-through cable with DB-9 connectors on either end.
To connect MP-124 to a PC, take these 2 steps:
1. Connect the DB-9 connector (refer to the figure below for connector pinouts) on one
end of the cable to the MP-124 RS-232 port (labeled RS-232).
2. Connect the DB-9 connector (refer to the figure below for connector pinouts) at the
other end of the cable to either the COM1 or COM2 RS-232 communication port on
your PC.
For information on establishing a serial communications link with the MP-124, refer to
Accessing the CLI.
2.2.4.5

Connecting MP-124 to Power

The MP-124 can be powered either from a standard AC electrical outlet or a 48-VDC power
supply. The power configuration depends on the ordered MP-124 model.
2.2.4.5.1 AC Power Supply
The cabling of the MP-124 model for AC power is described below.
To connect MP-124 to the AC power supply, take this step:
Connect the MP-124 AC power socket (located on the rear panel) to a standard
electrical wall outlet, using the supplied AC power cord.
Version 5.6

Figure 2-20: MP-124 RS-232 Connector Pinouts

27
2. Installing the Device
November 2008