1
Warnings
Warnings
•
Read all installation instructions and site survey reports, and verify correct
equipment installation before connecting the access point to its power source.
•
Remove jewelry and watches before installing this equipment.
•
Verify that the unit is grounded before connecting it to the power source.
•
Verify that any device connected to this unit is properly wired and grounded.
•
Connect all power cords to a properly wired and grounded electrical circuit.
•
Verify that the electrical circuits have appropriate overload protection.
•
Attach only approved power cords to the device.
•
Verify that the power connector and socket are accessible at all times during
the operation of the equipment.
•
Do not work with power circuits in dimly lit spaces.
•
Do not install this equipment or work with its power circuits during
thunderstorms or other weather conditions that could cause a power surge.
•
Verify there is adequate ventilation around the device, and that ambient
temperatures meet equipment operation specifications.
•
Before installing or handling the
an ESD wrist strap or other ESD voltage limiting device.
Site preparation
•
Consult your site survey and network analysis reports to determine specific
equipment placement, power drops, and so on.
•
Assign installation responsibility to the appropriate personnel.
•
Identify and document where all installed components are located.
•
Provide a sufficient number of power drops for your equipment.
•
Ensure adequate, dust-free ventilation to all installed equipment.
2
CAUTION
For safety reasons, the ESD wrist strap should contain a 1 meg ohm series
resistor.
Brocade Mobility 7131 Series Access Point Installation Guide
Mobility 7131 Series
Access Points, have on hand
53-1001935-02