Brocade Communications Systems Mobility 7131 Series Installation Manual page 20

Mounting the access point
NOTE
It is recommended the access point be mounted with the RJ45 cable connector
oriented upwards or downwards to ensure proper operation.
11. Cable the Mobility 7131 Series Access Point using either the Power over
Ethernet (PoE) or an approved line cord and power supply.
For POE installations, connect an RJ-45 CAT5e (or CAT6) Ethernet cable
between a PoE switch port and the Brocade Mobility 7131 GE1/POE port.
For standard power adapter and line cord installations:
a. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data
supply (host) and the Mobility 7131 Series Access Point GE1/POE or GE2
port.
b. Verify the power adapter is correctly rated according the country of
operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable into the power connector on the Mobility
7131 Series Access Point .
e. Attach the power supply line cord to a power supply.
12. Verify the behavior of the access point LEDs. For more information, see
indicators"
13. The access point is ready to configure. For information on basic access point
device configuration, see
Brocade Mobility 7131 Series Access Point Installation Guide
53-1001935-02
CAUTION
Ensure you are placing the antennas on the correct connectors
(depending on your single or dual-radio model and frequency used) to
ensure the successful operation of the access point.
CAUTION
Do not actually connect to the power source until the cabling portion of
the installation is complete.
on page 19.
"Configuring basic device settings"
2
"LED
on page 29.
13