Brocade Communications Systems Mobility 7131 Series Installation Manual page 24

Mounting the access point
•
Badge for light pipe
•
Decal for badge
•
Safety wire (strongly recommended)
•
Security cable (optional)
To install the access point above a ceiling:
NOTE
Remove the access point's facade and antennas before installing in an above the
ceiling orientation. The access point is not certified for an above the ceiling
installation with its accessories installed.
1. If possible, remove the adjacent ceiling tile from its frame and place it aside.
2. If required, install a safety wire, between 1.5mm (.06in.) and 2.5mm (.10in.) in
diameter, in the ceiling space.
3. If required, install and attach a security cable to the access point's lock port.
4. Mark a point on the finished side of the tile where the light pipe is to be
located.
5. Create a light pipe path hole in the target position on the ceiling tile.
6. Use a drill to make a hole in the tile the approximate size of the access point
LED light pipe.
7. Remove the light pipe's rubber stopper (from the access point) before installing
the light pipe.
Brocade Mobility 7131 Series Access Point Installation Guide
53-1001935-02
CAUTION
Brocade recommends care be taken not to damage the finished
surface of the ceiling tile when creating the light pipe hole and
installing the light pipe.
2
17