Turn On/Off The Power Of The Recorder; Turn On The Power Of The Recorder; Turn Off The Power Of The Recorder; During Recording - Panasonic WJ-ND400K Installation Manual

Turn on/off the power of the recorder

■ Turn on the power of the
recorder

Turn on the power of the recorder.

1
Insert the power plug into an outlet.
120 V AC 60 Hz, for the NTSC model
220 V to 240 V AC 50 Hz, for the PAL model
Use the power source that is suited to your model.
2
Press the POWER switch at the rear of the recorder
to turn on the power.
• The [OPERATE] indicator will light and the system check
(checking the system and hard disk drives) will start.
• The "WJ-ND400" indication will be displayed on the LCD
at startup, and the "Initializing" indication will be displayed
during startup.
The "Initializing" indicatior will turn to "Don't turn off" after a
short time.
• When the system check is complete, the time and date
display (standby display) will be displayed on the LCD.
(Page 41)
Important:
• Do not turn off the power during the power on process.
• When using the extension units (WJ-HDE400), turn on the
power of the recorder after turning on the power of all the
extension units.
40
■ Turn off the power of the
recorder
To shutdown the recorder, do the following.
Important:
• Remove the plug from the outlet if not operating the
recorder not in use long.
• When the recorder has not been used for a certain period,
turn on the power of the recorder (approximately once a
week) and perform recording/playback to prevent interfer-
ences with functions.
● During recording
1
Select "Off" for "Recording" under "Basic" on the
setup menu to stop all recordings. (Refer to the
setup instructions (PDF).)
2
Turn off the power of the recorder after confirming
that all the HDD access indicators are off.
The [OPERATE] indicator will go off.
Note:
• After turning on the power of the recorder again, do not
forget to set the "Recording" setting under "Basic" to "On".
● During playback
1
Click the [STOP] button on the [HDD] tab on the
operation window. (Refer to the operating instruc-
tions (PDF).)
2
Turn off the power of the recorder after confirming
that all the HDD access indicators are off.
The [OPERATE] indicator will go off.