Connection 1 For The Auto Adjustment Time Function; Connection 2 For The Auto Adjustment Time Function - Panasonic WJ-ND400K Installation Manual

● Connection 1 for the auto adjustment time function
When "Auto adjustment time" of "Time & date" under "Basic" on the setup menu is set to "Master"
"Time adjust output" becomes available and the clock of this recorder will be applied to other devices.
The time adjust output signal will be supplied from pin no.20 to other recorders at the time set for "Activation time" of "Time & date"
under "Basic" on the setup menu.
13
ALARM/CONTROL
● Connection 2 for the auto adjustment time function
When "Auto adjustment time" of "Time & date" under "Basic" on the setup menu is set to "Slave"
"Time adjust input" becomes available and the clock of this recorder will be applied to other devices.
When a signal output from other device is supplied to the time adjust I/O terminals (pin no.20) 15 minutes before/after the time set for
"Activation time", the clock of the recorder will be set to the time set for "Activation time".
Example:
When "15:00" is set for "Activation time"
• Signal is supplied at 2:50:00 (hour:minute:second) pm → Set at 3:00:00 pm
• Signal input supplied at 3:14:45 pm → Set at 3:00:00 pm
• Signal is supplied at 3:20:00 pm → Time will not be adjusted.
13
ALARM/CONTROL
Important:
• When "Slave" is selected, the clock will not be adjusted during event recording or emergency recording.
(Signal ground)
(Time adjustment output)
20
(Signal ground)
(Time adjustment input)
20
Terminal for other devices
Front panel
LED monitor
output
Terminal for other devices
Front panel
LED monitor
output
35