Position In The Rack - Panasonic WJ-ND400K Installation Manual

■ Position in the rack

When connecting extension units (WJ-HDE400) to the recorder, install the recorder in the center of the rack.
Connect the recorder and the extension unit using the connection cable (1 m {39.4"}) provided with the extension unit. (Page 32)
Extension unit
(unit number 5)
Extension unit
(unit number 4)
Network Disk
Recorder
Extension unit
(unit number 1)
Extension unit
(unit number 2)
Extension unit
(unit number 3)
Note:
• Install the recorder in the center of the rack. When the recorder is installed at the top or the bottom of the rack, it may have diffi-
culties in connecting the extension units since the cable length is not long enough.
• When installing the recorder in the rack, leave a space of 1U (44 mm {1.73"}) above and below the recorder for ventilation.
• Fix the connection cable firmly using the cable clamp provided with the extension unit.
When the cable is not connected firmly or when it is disconnected, the system may become unstable or recording may fail.
• Do not leave the connected cables unnecessarily long and loose. If the wiring route is unnecessarily detoured or the distance
between devices is too far, it may cause malfunction. Do not wind the cable in a coil.
• Refer to the setup instructions (PDF) for information on how to check the unit numbers of the connected extension units.
Connection cable
(provided with extension unit)
Require a space of 1 unit
(44 mm {1.73''})
Require a space of 1 unit
Require a space of 1 unit
Require a space of 1 unit
Require a space of 1 unit
25