Prowler Hdx; Removing Engine/Transmission - Arctic Cat 2011 Prowler HDX Service Manual

Prowler HDX

(Table of Contents)

Removing Engine/Transmission.............................. 3-6

Top-Side Components............................................. 3-9
Removing Top-Side Components ........................... 3-9
Servicing Top-Side Components........................... 3-13
Installing Top-Side Components ........................... 3-20
Left-Side Components .......................................... 3-25
Removing Left-Side Components ......................... 3-25
Installing Left-Side Components ........................... 3-27
Right-Side Components ........................................ 3-30
Removing Right-Side Components....................... 3-30
Servicing Right-Side Components ....................... 3-33
Installing Right-Side Components......................... 3-34
Center Crankcase Components............................ 3-37
Separating Crankcase Halves............................... 3-38
Disassembling Crankcase Half ............................. 3-38
Servicing Center Crankcase Components............ 3-40
Assembling Crankcase Half .................................. 3-46
Joining Crankcase Halves..................................... 3-47
Installing Engine/Transmission.............................. 3-48
Removing
Engine/Transmission
Many service procedures can be performed without
removing the engine/transmission from the frame.
Closely observe the note introducing each sub-section for
this important information.
AT THIS POINT

If the technician's objective is to service/replace
right-side cover oil seals, front output joint oil seal,
rear output joint oil seal, and/or the oil strainer (from
beneath the engine/transmission), the engine/trans-
mission does not have to be removed from the
frame.
Support the vehicle on a suitable lift or jack stands allow-
ing room to perform work from the underside.
NOTE: Locate the jack stands to allow removing
of the center belly panel.
! WARNING
Make sure the vehicle is solidly supported on the
support stands to avoid injury.
1. Remove the seat, seat back, and seat base; then
remove the battery cover and disconnect the nega-
tive battery cable.
2. Remove the center skid plate; then drain the oil
and coolant.
3-6
3. Remove the center floorboard.
4. Marking all nylon tie locations for installing pur-
poses, from the right side disconnect the MAP
sensor connector (A), fuel injector connector (B),
ISC connector (C), and TPS connector (D).
5. Wrap the gasline hose connector with a shop cloth;
then remove the gasline hose connector from the
fuel rail.
Gasoline may be under pressure. Place an absorbant
towel around the connector to absorb any gasoline
spray when disconnected.
6. Loosen the clamp securing the air filter intake tube
to the air filter; then remove the mounting screw
and remove the intake tube.
Manual
Table of Contents
! WARNING
HDX136A
HDX138A
HDX031A