Panasonic CQ-VAD9200U Operating Instructions Manual page 86

Multi channel in-dash 7 inch wide color lcd tv / dvd-video / receiver
Hide thumbs Also See for CQ-VAD9200U:
Table of Contents

Advertisement

Troubleshooting
E
N
G
L
I
MP3 (Continued)
S
H
Trouble
81
File playing time is not
displayed correctly.
Radio
Trouble
Poor reception of FM
stereo and monaural
broadcasts.
Car Navigation, VCR, Camcorder, Rear View Camera, Rear Monitor
Trouble
The picture from a car
navigation system is
not displayed.
The picture from a VCR or a
camcorder is not displayed.
No sound from a VCR or
a camcorder.
The picture from a rear
view camera is not dis-
played.
The picture or the sound
of the rear monitor is not
switchable.
90
CQ-VAD9200U
(continued)
You turned off the ignition switch of the car during playback.
a
Playing another file will return the file playing time to normal.
You played a file in which character information had been recorded by use of
ID3Tag 2.0 or later version.
a
A file in which character information was recorded by use of ID3Tag 2.0
or later version may not be reproduced normally. For example, the file
playing time may not be displayed correctly.
Station is too far, or signals are too weak.
a
Select other stations of higher signal level.
The motor antenna relay control lead is not connected correctly.
a
If there is a motor antenna in the car, connect the motor antenna relay
control lead to the motor antenna lead that is installed in the car correctly.
The radio antenna is not extended enough.
a
Fully extend the radio antenna.
The connection of a car navigation system is not correct.
a
Connect it correctly.
Input setting of a car navigation system is not correct.
a
Make the input setting correct.
A VCR or Camcorder is not connected correctly.
a
Connect a VCR or Camcorder correctly.
The VTR1-IN and/or VTR2-IN level is excessively high. (The "OVER" display
appears.)
a
Adjust the VTR Input level.
Rear view camera is not connected correctly.
a
Connect a rear view camera correctly.
Input setting of a camera is not correct.
a
Make the input setting correct.
"AUTO" is not selected for the setting of a rear monitor.
a
Select "AUTO" for the setting.
Cause / Step
Cause / Step
Cause / Step

Advertisement

Table of Contents
loading

Table of Contents