Trouble
Only sound,
no picture.
Noise
Picture is not clear.
■
Monitor
Trouble
The tilt angle or the
front-rear position of
the display is not
adjustable.
The monitor does not
go back into the unit.
■
Remote Control
Trouble
Buttons are invalid for
operation.
■
TV
Trouble
Unclear image due to
noise
Side brake (parking brake) lead is not correctly connected.
a
Connect the side brake connection lead correctly.
You did not pull the side brake (parking brake) lever.
a
Pull the side brake (parking brake) lever.
A mobile phone is used near the unit.
a
Keep the mobile phone away from the unit.
There is an obstacle.
a
Install the unit where the unit moves freely.
The monitor direction is not proper.
a
Change the monitor direction to the center.
The monitor stops on the way to the home position.
a
Raise the monitor a little and press [
Battery poles (+) (–) are reversed.
a
Insert the battery correctly.
Wrong battery.
a
Check the battery.
Battery has run down.
a
Replace the battery.
Remote control is in the wrong direction.
a
Direct the remote control at remote control sensor on the display unit.
The intensity of the radio wave is too low.
a
Change the broadcast station.
Connection or installation of the TV antenna has not been performed correctly.
a
Check the connection or installation.
Cause / Step
Cause / Step
] (OPEN/CLOSE).
Cause / Step
Cause / Step
CQ-VAD9200U
E
N
G
L
I
S
H
78
87