Table of Contents
Advertisement
Cautions:
¡Never mount the unit in any of the following locations to avoid damage due to overheating;
1. Near the heater port.
2. Places like the dashboard or rear deck, where it may be exposed to direct sunlight.
¡Do not mount the unit near the door, where it could be exposed to rain.
¡Do not separate the hide-away unit.
❑ Mount the unit on the car carpet by using Velcro Tape @3 .
Attach the seal side of the Velcro Tape @3
to the hide-away unit, then mount the unit
on the carpet.
Note: Some carpet materials may not be
suitable for this mounting method. In this
case, please contact your nearest
Panasonic Servicenter for installation.
❑ Unit installation by using the Mounting Brackets @0 and the Base Brackets @1 .
Let the bolts of
the base bracket
pass the carpet.
Make cuts by
using cutter.
Note: Apply an anticorrosive to the holes and tapping screws.
Caution: You run the risk of interfering with the mounting or causing damage by drilling into the gas tank, a wiring
harness, or other component.
Mounting the Hide-away Unit
Carpet
@1 Base Bracket
Drill for 4.8 mm diameter holes to the chassis.
* Put the tape and the base bracket together with each hole of the tape and
bracket connected so that the screw goes in at two positions.
!9 Hex. Nut (M5)
@0 Mounting Bracket
!7 Binding-Head Screw
(M5 x 8 mm)
!8 Tapping Screw (ø 6 x 20 mm)
@2 Double-Faced Adhesive Tape
CQ-VAD9200U
E
N
G
L
I
S
H
66
@3 Velcro Tape
75
Advertisement
Table of Contents
