Table of Contents
Advertisement
[MODE]
(End)
[0] to [9]
3
Setting
q Press [}] or [{] to select
an item.
w Press [[] , []] , [}] or
[{] to select or adjust the
setting.
e Press [ENTER] to set.
Press [0] to [9] on the remote
control to input the ID code.
Caution: Record your regis-
tered ID code and keep it in a
secure location. If you forget it,
you will be unable to use the
unit. In case you forget the ID
code, please consult your near-
est Panasonic Servicenter.
[MENU]
[}] [{]
[]] [[]
(Select/Adjust)
[ENTER]
CAMERA INPUT
OFF
: Unconnected
: Connected to the VTR1-IN
VTR1
: Connected to the VTR2-IN
VTR2
Note: Make sure to select "OFF" when no rear view camera is connected.
SCALE
OFF
: Scale display off
ON
: Scale display on
SCALE ADJUST
Press [[] or []] to adjust the width.
Press [}] or [{] to adjust the angle.
How to set your ID code (for the first time)
q Enter an 4 digit ID code.
w Enter the same 4 digit ID code again.
How to change your ID code
q Enter the preset (old) 4 digit ID code. If the wrong ID code is entered, a
new ID code cannot be registered.
w Enter a new 4 digit ID code.
e Enter the new 4 digit ID code again.
How to cancel the known ID code
Note: Should your unit ever require service, cancel your ID code before send-
ing for repair.
q Enter the preset (old) 4 digit ID code. If the wrong ID code is entered, it is
not possible to cancel the ID code function.
w Press and hold [ENTER] until " Complete! " is displayed . The ID code can-
celling procedure is completed. The unit now works without an ID code.
Note: Refer to ID Code Input regarding how to enter the ID code.
Notes:
¡Press [MODE] to return to the regular mode.
¡The display returns to the previous one if there is no
operation for more than 60 seconds after changing to
the setting menu.
Rear view camera input
Rear view camera scale display
Scale adjustment
CQ-VAD9200U
E
N
G
L
I
S
H
32
(a
page 11)
41
Advertisement
Table of Contents
