Superio Device - INSIGHT P4-ITX User Manual

SuperIO Device

Press Enter to enter the sub-menu and the following screen appears:
Onboard FDC Controller
Enable the onboard floppy controller. Select
installed a floppy disk drive. Settings:
Onboard Serial Port 1/2
Set the base I/O port address and IRQ for the onboard serial port A/serial
port B. Selecting
correct base I/O port address. Settings:
IRQ4, 2E8/IRQ3
Onboard Parallel Port
This specifies the I/O port address and IRQ of the onboard parallel port.
Settings:
Disabled, 378/IRQ7, 278/IRQ5
allows BIOS to automatically determine the
Auto
and
Auto
Enabled
and
Enabled
Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/
and
3BC/IRQ7
3-17
BIOS Setup
when you have
Disabled