AGP Driving Control
The setting is used to adjust AGP driving force. Selecting Manual allows
you to type a AGP driving force in AGP Driving Value. It is strongly sug-
gested to select Auto to avoid causing any system error. Settings: Auto and
Manual.
CPU to PCI POST Write
When
, CPU can write up to four words of data to the PCI write
Enabled
buffer before CPU must wait for PCI bus cycle to finish. If
must wait after each write cycle until PCI bus signals that it is ready to
receive more data. Settings:
Select Display Device
This setting refers to the type of display being used with the system.
Settings:
CRT, TV, CRT + TV, LCD
TV Type
This setting refers to the type of TV signal to be used when a TV is
connected to the TV-out. Settings:
TV_Connector
This setting refers to the type of TV connector being used when a TV is
connected to the TV-out. Settings:
G/B, SDTV-Pr/Y/Pb and S-Video 1.
Panel Select
This setting refers to the native resolution of the display being used with the
system. Settings:
VGA Share Memory Size
This setting refers to the VGA share memory size. Settings:
.
32M
Enabled
and
1024x768, 800x600
and
Disabled
CRT + LCD
and
NTSC, PAL
PALM
CVBES, S-Video 0, R/G/B, Cr/Y/Cb, SDTV-R/
and
640x480
3-13
BIOS Setup
, CPU
Disabled
and
8M, 16M