Hdd Led - INSIGHT P4-ITX User Manual

Chapter 2
Power Switch
Connect to a 2-pin push button switch. Pressing this button will turn the sys-
tem power on or off.
Reset Switch
The Reset Switch is used to reboot the system rather than turning the power
ON/OFF. Avoid rebooting while the HDD is working. You can connect the
Reset Switch from the system case to this pin.
Power LED
The LED is lit when the system is power on. If the system is in S1 (POS -
Power On Suspend) or S3 (STR - Suspend To RAM) state, the LED will
blink.

HDD LED

HDD LED shows the activity of a hard disk drive. Avoid turning the power
off while HDD LED is lit. Connect the HDD LED from the system case to
this pin.
SLED
The SLED is lit when the system is in the S1 (POS - Power On Suspend)
state.
Speaker
The speaker from the system case is connected to this pin.
Floppy Disk Drive Connector: FDD
The floppy disk drive connector supports 360K, 720K, 1.2M. 1.44M, and
2.88M floppy disk types.
N
A
FDD
2-14