First/Second/Third Boot Device
Set the boot device sequence as BIOS attempts to load the disk operating
system. The settings are:
Floppy
LS120
HDD-0
SCSI
CD-ROM
HDD-1
HDD-2
HDD-3
ZIP100
USB-FDD
USB-ZIP
USB-CDROM
USB-HDD
LAN
Disabled
Boot Other Device
Enable the system to boot from other devices if the system fails to boot from
the First/Second/Third boot device. Settings:
Swap Floppy Drive
If the system has two floppy drives, choose
B to logical drive A and vice versa. Settings:
Boot Up Floppy Seek
Set floppy seek during POST, BIOS will determine whether the floppy is 40
or 80 tracks. Settings:
The system will boot from floppy drive.
The system will boot from LS-120 drive.
The system will boot from first HDD.
The system will boot from SCSI.
The system will boot from CD-ROM.
The system will boot from second HDD.
The system will boot from third HDD.
The system will boot from fourth HDD.
The system will boot from ATAPI ZIP drive.
The system will boot from USB floppy drive.
The system will boot from USB ZIP drive.
The system will boot from USB CDROM.
The system will boot from USB HDD.
The system will boot from network drive.
Disable this sequence.
and
Enabled
Disabled
3-9
and
Enabled
Disabled
to assign physical drive
Enabled
and
Enabled
Disabled
BIOS Setup