Table of Contents
Advertisement
Chapter 3
Boot Up NumLock Status
Set the NumLock status when the system is powered on.
pad into number keys, and
and
Off
Typematic Rate Setting
When
, the following two items (Typematic Rate and Typematic
Disabled
Delay) are irrelevant. Keystrokes repeat at a rate determined by the keyboard
controller in your system. When
typematic delay. Settings:
Typematic Rate (Chars/Sec)
When Typematic Rate Setting is enabled, this item allows you to set the rate
(characters/second) at which the keys are accelerated. Settings:
and
15, 20, 24
30
Typematic Delay (Msec)
When Typematic Rate Setting is enabled, this item allows you to select the
delay between when the key was first pressed and when the acceleration
begins. Settings:
Security Option
If you have set a password, select whether the password is required every
time the System boots, or only when you enter Setup. Settings are described
below:
Setup
System
MPS Version Control For OS
Choose which MPS version control for OS. Settings: 1.1 and 1.4.
will turn key pad into arrow keys. Settings:
Off
Enabled
Enabled
and
250, 500, 750
The password prompt appears only when end users
try to run Setup.
A password prompt appears every time when the
computer is powered on or when end users try to
run Setup.
, you can select a typematic rate and
and
Disabled
1000
3-10
will turn key
On
On
6, 8, 10, 12,
Advertisement
Table of Contents
