CHASSIS ELECTRICAL
Inspection of Wiper Relay (Built-in Column Switch)
(1) Check to ensure that there is continuity between terminals
there is no continuity between terminals @ and 0.
(2) Connect the positive terminal of the battery to terminal @
and the negative terminal to terminal @ to check that the
battery voltage is available at terminal @.
INSPECTION OF WASHER MOTOR
mounted on the washer tank and that the washer tank is
filled with water.
(2) Connect the battery as shown to check whether water is
pumped out.
INSPECTION OF WASHER FLUID LEVEL SENSOR
as shown.
(2) Check that when the float is moved down, the circuit is
closed and that when the float is moved up, the circuit is
opened.
SERVICE POINTS OF INSTALLATION
2. INSTALLATION OF WIPER ARM
Check the identification symbol.
(2) After the wiper blades have been set, install them in
such a way that the ends of the wiper blades will stop at
the specified positions (standard yalues).
Standard value: (A) 15 '3