Replacement Of Brushes And Springs; Brush Holder Check; Overrunning Clutch Check - Dodge Stealth 1994 Service Manual

ENGINE ELECTRICAL
Undercut
(3) Check the depth of the undercut between segments.
Standard value: 0.5 mm (.020 in.)
BRUSH HOLDER
Check for continuity between brush holder plate and brush
holder.
The normal condition is non-continuity.
OVERRUNNING CLUTCH
1. While holding clutch housing, rotate the pinion. Drive pinion
should rotate smoothly in one direction, but should not
rotate in opposite direction. If clutch does not function
properly, replace overrunning clutch assembly.
2. Inspect pinion for wear or burrs. If pinion is worn or burred,
replace overrunning clutch assembly. If pinion is damaged,
also inspect ring gear for wear or burrs.
FRONT AND REAR BRACKET BUSHING
Inspect bushing for wear or burrs. If bushing is worn or burred,
replace front bracket assembly or rear bracket assembly.

REPLACEMENT OF BRUSHES AND SPRINGS

1. Brushes that are worn beyond we;
should be replaced.
2. When replacing field coil brushes, crush worn brush witt
pliers, taking care not to damage pigtail.
1