The Sensor Does Not Send An Alarm - Wespot SecNurse User Manual

Red LED flashes rapidly after activation
If the red LED starts to flash rapidly just after you tried to activate the sensor, the bed zone
has not been configured properly. Possible errors:
- Wrong corners have been configured.
- Both of the corners have been configured as "wall/head".
Please reconfigure the bed zone according to chapter 3, Installation.
Yellow, red and green LED flash
The sensor is defect. Please contact your installer.

The sensor does not send an alarm

In extreme situations it can happen that the sensor does not detect when the patient
leaves the bed or sits on the bed edge. If this happens repeatedly the following could be
done:
1. Configure the bed zone (see chapter 3, Installation).
2. Check if the time is set correctly (see chapter 3, Installation).
3. Move away pieces of furniture placed nearby the bed (see chapter 5, Consider the
following).
4. Move away the TV or any other light source near the bed (see chapter 5, Consider the
following).
5. Change clothes (see chapter 5, Consider the following).
Another possible reason is that a prior alarm has not been confirmed and the sensor has
not been reactivated.
- 27 -
7. Troubleshooting