hager LCP01X User Manual page 58

G
Questions
Why does the handset not
display the status of the
motorisation system connected?
Why does the outdoor caller unit
issue 3 error beeps when a tag is
held up to it?
Why is the "BATTERY ACCESS
X" message displayed?
Why is the "CHARGE
HANDSET" message displayed?
Why is the "MEMORY FULL"
message displayed when a radio
link is created?
Why is communication with
another handset impossible?
What does the
displayed on the handset mean?
How can I change the access
code, e.g. from 4 to 6 digits?
What should I do if I cannot
operate the latch?
When a radio link is created between a handset and the
controller, the position contact must be closed. If this was not
the case when the link was created, it must be deleted and
recreated (see Appendix/Deleting radio links and then
Creating a radio link between a handset and several
controllers or several outdoor caller unit call buttons).
For a Hager brand automatic control system, check the wiring
and check for any short-circuits between terminal blocks 9
and 10.
For an automatic control system belonging to another brand:
• check that the position contact is connected to terminal
blocks 9 and 10,
• when there is a position contact connected, place the gate
in a position so that the position contact is closed and
check that it is displayed on the screen.
The tag has not been registered (see Programming doorphone
operating functions).
Change the controller batteries (see Appendix/Changing the
batteries). It is advisable to change the handset battery at the
same time.
Put the handset on the base to charge it.
The handset's memory capacity has been reached.
Delete some of the radio links (see Appendix/Specific cases/
Creating a radio link between several handsets).
Check there is a radio link between the handsets
(see Appendix/Specific cases/Creating a radio link
between several handsets).
icon A visitor came to the outdoor caller unit while you were out.
To delete the icon, press on the handset button.
• Delete all the programmed codes
(ACCESS/CODES/DELETE menu)
• Modify the size of the access codes
(ACCESS/CODES/SIZE menu)
• Reprogramme all the codes
(ACCESS/CODES/ADD menu)
Check the wiring and its characteristics (12 V, 1.5 A max.).
If the latch is an addition to the initial installation, the existing
radio link must be deleted and a new one created (see
Appendix/Deleting radio links and then Creating a radio link
between a handset and several controllers or several outdoor
caller unit call buttons).
Answers
232