Installing The Controller - hager LCP01X User Manual

G

5.2 Installing the controller

1. Unscrew the locking screw from the
bracket and then remove it.
Pozidriv 2
Installation rules
To make it easier to hook the base on to the bracket choose a flat surface (or make the surface as
flat as possible) on the garden side of the pillar. This is especially important for the top part of the
bracket.
To guarantee an excellent radio range:
• keep the space clear around the controller,
• remove any dense vegetation nearby and
make sure the area is always clear,
• place the controller as high up as possible
(80 cm min.).
• make sure there are no obstacles between
the controller installation point and the house
where the handset(s) is/are installed.
Never run a cable over the top of the
controller (especially the cable ensuring
the radio link between the outdoor
caller unit and the controller). Do not
wind the cable up nearby or inside the
controller. Instead, cut off any excess
length.
Do not place the products near metal surfaces (screens, fences, gates, etc.) or sources of
electromagnetic disturbance:
• for the controller: electricity meter, high voltage line, lighting control system, radio receiver, etc.
• for the handset: hi-fi equipment, video, household appliance, electricity meter or switchboard,
lighting control system, etc.
• the controller must be more than 3 m away from the interior handset unit.
2. Following the installation rules below,
mark 3 fixing points and drill a hole
in the pillar using a Ø 6 mm drill bit.
minimum
Outdoor caller unit
cable feed
as high
as
possible
outdoor
caller unit
caller unit
cable
194
4 cm
caller unit
cable
outdoor
caller unit