Panasonic KX-TVS120 Installation Manual page 311

Parameter
Operator
Transfer
Sequence
Extension
Transfer
Sequence
Alternate
Extension
Transfer
Sequence
Reconnect
Sequence on
Busy
Reconnect
Sequence on
No Answer
Reconnect
Sequence on
Refuse Call
Light-On
Sequence for
Message
Waiting Lamp
Light-Off
Sequence for
Message
Waiting Lamp
Call Waiting
Sequence
Release
Sequence for
Call Waiting
Inband Signaling Parameters
Use these parameters if the PBX sends touchtones to the VPS to indicate the state of a call
(busy, answered, disconnected, etc.). The integration mode must be set to "Inband". If PBX
type is set to a KX-T series telephone system, the Inband Signaling parameters will
automatically default to the proper codes.
Installation Manual
Table 79
Value Range
(Default)
The VPS performs this sequence when transferring calls
(FX) to the operator's extension.
The VPS performs this sequence when transferring calls
(FX) to any extension except the operator's.
The VPS performs this sequence when transferring calls
to extensions in the Alternate Extension Group.
(FX)
If an extension is busy, this sequence allows the VPS to
(F) reconnect to the caller.
If the extension does not answer, this sequence allows the
(F) VPS to reconnect with the caller.
The VPS performs this sequence to retrieve a call placed
(F) on hold after the extension (in the Call Screening mode)
has refused to accept it.
This is the dialing sequence that the VPS must perform to
enable the Message Waiting Lamp at an extension.
(None)
This is the dialing sequence that the VPS must perform to
disable the Message Waiting Lamp at an extension.
(None)
The VPS carries out this sequence when performing call
(1)
waiting if the extension being called is busy.
The VPS performs this sequence to release call waiting.
(F)
SYSTEM ADMINISTRATOR'S GUIDE
Description/Function
311