Duress Arm/Disarm; Personal Attack Alarm (Pa); Fire Alarm - Pyronix STERLING 10 User Manual

Sterling 10 User Manual
Once entered, the zone that was activated will be displayed (as above). To reset the system, enter
you user code again, and "SYSTEM DISARMED" will be shown.
If the panel is not reset, then your engineer has enabled engineer or Anti-code reset. Please contact
your installation company.

2.7 Duress Arm/Disarm

Enter your User Code, with the last 2 digits transposed. For example, if your code is 1 2 3 4, enter 1 2
4 3. The panel will appear normal, but a silent PA (Personal Attack) alarm will be sent to the Alarm
Receiving Centre (if connected).

2.8 Personal Attack Alarm (PA)

To activate the personal attack alarm:
Func
LCD Keypad: press the key and then the
Enter
ICON Keypad: press the key and then the
P.A.
Fire
To disarm the Personal Attack, enter your user code.

2.9 Fire Alarm

To activate the Fire alarm:
Func
LCD keypad: Press the key and then the
Enter
ICON Keypad: Press the key and then the
P.A.
Fire
To disarm the Fire activation, enter your user code.
Page: 6
P.A.
key
key.
SYSTEM DISARMED
STERLING
ARM
A B C
ABC DEF GHI
Func
D
Enter
JKL M N O P Q R
S T U V W X YZ SPACE
Fire
key.
key.
SYSTEM DISARMED
STERLING
ARM
A B C
A B C D E F G H I
Func
D
Enter
JKL M N O P Q R
S T U V W X YZ SPACE
Deleting a Limited User Code
LCD Keypad
Press the
Then the
Scroll to 'CHANGE CODES'
Press the
The following will be displayed
Enter your 4-digit Master User Code (Default 1234).
Enter any number from 2 to 7 to select the user code you wish to delete.
Then press the
user code you chose has been deleted.
3.5 AC Mains Loss (Fault Tone)
If the AC mains fails, Power Fail will be shown on the display, and a fault tone will sound every 5
seconds.
The panel will automatically run off backup battery when there is a mains fail.
To clear the fault tone, press the
RINS415-9 RINS415-9
Func
key
Enter
key
Func
key to accept.
Enter
CHANGE CODES
ENTER NEW CODE
P.A.
A B C
A B C D E F G H I
Fire
D
JKL M N O P Q R
S T U V W X YZ SPACE
key to delete the code. An acceptance tone will be heard, stating that the
Func
key.
Enter
Sterling 10 User Manual
STERLING
ARM
Func
Enter
Page: 15