Chapter 7 Disassembly And Installation; Remove Packing Materials; Adjusting The Dryer; Location Of Your Dryer - Haier GDG480BW Service Manual

Service Manual
Order No. TL1206S003V1.1

Chapter 7 Disassembly and Installation

7-1. Remove packing materials

1. Remove all packaging material. This includes the foam base and all adhesive
tape holding the dryer accessories inside and outside.
2. Inspect and remove any remains of packaging, tape or printed materials
before using the dryer.

7-2. Adjusting the Dryer

There are adjustable feet under the bottom of the
dryer. Before use, the dryer should be adjusted,
as shown in the right figure, so that it is level.

7-3. Location of your dryer

Do Not Install Your Dryer:
1. In an area exposed to dripping water or outside weather conditions.
2. In an area where it will come in contact with curtains, thick carpet, or anything
that will obstruct the flow of combustion and ventilation air.
3. On carpet, floor must be solid with a maximum slope of 1inch (2.54 cm). Any
floor unevenness should be corrected with leveling legs located on the bottom
of the dryer.

7-4. Installation in Alcove or Closet:

1. DO NOT install your dryer in a closet with a solid door.
2. A dryer installed in a bedroom, bathroom, alcove or closet MUST be exhausted outdoors.
3. No other fuel burning appliance shall be installed in the same closet as the gas dryer.
4. Refer to the images on this page to ensure the installation provides the minimum amount of
clearance required for ventilation.
5. When installing the dryer in a closet with a door, a minimum of 120 square inches (774.2
square cm) of ventilation in the door is required. Openings must be equally divided at the
top and bottom of the door and airflow must be unobstructed. A louvered door with
equivalent air openings for the length of the door is acceptable.
- 13 -
Issue
Rev.