Natural Gas To Lp Gas Conversion Kit - Haier GDG480BW Service Manual

Service Manual
Order No. TL1206S003V1.1
Chapter 7 Disassembly and Installation
Installation Instructions, Cont'd
6. Using the measurements from Step 4, install (2)
in Figure 2 using (4)
7. Move dryer back into place so that the rear leveling feet engage the hold down brackets.
8. Install the exhaust duct.
9. With the dryer in place, install the two remaining hold down brackets to engage the front
leveling feet.
11.0 in (280mm)
to edge of bracket
1.0 in (25mm)
to edge of
bracket
7-8. Installation Instructions
Natural Gas to LP Gas Conversion Kit No. 0030807989
THIS CONVERSION KIT SHALL BE INSTALLED BY A QUALIFIED SERVICE AGENCY IN ACCORDANCE WITH THE
MANUFACTURER S INSTRUCTIONS AND ALL APPLICABLE CODES AND REQUIREMENTS OF THE AUTHORITY
HAVING JURISDICTION. THE INFORMATION IN THESE INSTRUCTIONS MUST BE FOLLOWED TO MINIMIZE
THE RISK OF FIRE OR EXPLOSION OR TO PREVENT PROPERTY DAMAGE, PERSONAL INJURY, OR DEATH.
THE QUALIFIED SERVICE AGENCY IS RESPONSIBLE FOR THE PROPER INSTALLATION OF THIS KIT. THE
INSTALLATION IS NOT PROPER AND COMPLETE UNTIL THE OPERATION OF THE CONVERTED APPLIANCE IS
CHECKED AS SPECIFIED IN THE MANUFACTURER S INSTRUCTIONS SUPPLIED WITH THIS KIT .
0030101240 #10 X 1/2" Wood Screw. Note the correct bracket orientation.
WALL
11.0 in (280mm)
to edge of bracket
WARNING
- 16 -
Hold Down Brackets as shown
0030101225
Line indicating the distance
from the wall to the back of
the dryer
1.0 in (25mm)
to edge of
bracket
Correct Bracket Orientation
Issue
Rev.
TOP VIEW
Figure 2
WARNING