Haier GDZ5-1 Service Manual
Haier gdz5-1 front loading dryer
Hide thumbs
Also See for GDZ5-1:
- User manual (80 pages) ,
- Training and operating instructions (50 pages) ,
- Parts manual (5 pages)
Related Manuals for Haier GDZ5-1
Summary of Contents for Haier GDZ5-1
- Page 1 HAIER Front Loading Dryer Service Manual PART # WD-8888-22 HAIER AMERICA TRADING, LLC www.haieramerica.com...
-
Page 2: Table Of Contents
Table Of Contents Features Specifications Safety Caution Unpacking And Installation Troubleshooting Dimensions Names Of Parts Circuit Wiring... -
Page 3: Features
Features ● Three drying cycle, heat cool and synthetic. ● The support of front and rear make running balanced low noise. ● Straight exhaust of back-inhale styled make good airproof and high drying efficiency. ● After heat drying cool may protect clothes. -
Page 4: Specifications
Specifications Models GDZ5-1 Capacities Capacities 11lb Drum size 117L 2800rpm 220-240v/50Hz Motor size (hp) 250W/150W Features Type Direct Exhaust Controls Mechanism Temperature Settings 3 kinds Dry Sensor Reversible Door End of Cycle Signal Wrinkle Remover Tumble Easy Access Lint Filter... -
Page 5: Safety Caution
Safety Precautions WARNING! To reduce the risk of fire, electrical shock, or injury to persons when using this dryer, comply with the basic warnings listed below. WARNING! Failure to comply with these warning could result in serious personal injuries or damage to the dryer. WARNING! Do not dry items that have been previously cleaned in, soaked in, or spotted with gasoline, cleaning solvents, kerosene, cooking oils, waxes, etc. - Page 6 WARNING! Destroy the carton, plastic bag and other packing materials after the dryer is unpacked. Children might use them for play. Cartons covered with rugs, bedspreads or plastic sheets can become airtight chambers. WARNING! Keep laundry products out of children’s reach. To prevent personal injury, observe all warnings on product labels.
-
Page 7: Unpacking And Installation
Unpacking and Installation 1. Open the package, check against the instruction manual to see if the spare parts are complete. 2. Put the dryer to the location required by the user (balcony, kitchen, toilet or living room). According to the condition of the installation position, give the user advices on whether an exhaust pipe is used or not. -
Page 8: Troubleshooting
Troubleshooting A. The power light is on, but the machine does not work after a program is set. a. Check the micro switch. If it is out of order, replace it; otherwise, check to see if it is closed or it is open, check the switch arm height and adjust it. Maintenance Procedure: 1) Loosen the screws on the deck plate at the back to remove the deck plate, unplug the micro switch power line in the front channel. - Page 9 1) The overheat temperature controller of the heating component is turned off. Maintenance Procedure Remove the back guard plate, check to see if the high-temperature thermostat is in order. Check Procedure: Take down the cable plug and measure the high-temperature thermostat with an AVO meter to see if it is correct.
- Page 10 Maintenance Procedure 1) Open the deck plate, pull out the power line terminal, then open the back cover and remove the belt, pull out the power line terminal of the heater and remove the back cover. 2) Unscrew the drum holder on the front channel with a screwdriver and replace 3) Reinstall the dryer (the drum inner wall at the drum inlet must press on the drum holder, and the drum holder can be touched after the door is opened;...
-
Page 11: Dimensions
Dimensions Names of Parts... -
Page 12: Circuit Wiring
Circuit Wiring (New Zealand, Australia, Cyprus) Circuit Wiring (America and Canada)