Haier GDG480BW Service Manual page 17

Service Manual
Order No. TL1206S003V1.1
Chapter 7 Disassembly and Installation
THE CONVERSION SHALL BE CARRIED OUT IN ACCORDANCE WITH THE REQUIREMENTS OF THE
PROVINCIAL AUTHORITIES HAVING JURISDICTION AND IN ACCORDANCE WITH THE
REQUIREMENTS OF THE CSA B149.1, INSTALLATION CODE.
Important Note:
Installation of this kit converts the dryer from use with Natural Gas to use with LP
Gas for altitudes up to 4,500 feet above sea level. For installations at an altitude greater than 4,500
feet above sea level, contact a qualified service agency for derating instructions.
Parts List
1 0030101224 Regulator Blocking Plug
1 0030101223 Main Burner Orifice No. 55
1 00305027 06 LP Gas Conversion Plate Sticker
1 00305027 05 LP Gas Conversion Service Sticker (English)
1 00305027 05A LP Gas Conversion Service Sticker (French)
1 00305027 04 LP Gas Valve Sticker (English)
1 00305027 04A LP Gas Valve Sticker (French)
1 00305027 15 Instructions
Gas input - 20,000 BTU/HR
Before converting the dryer to LP Gas, verify
that the incoming gas supply line is equipped
with a pressure regulator (located ahead of the
dryer) that will maintain the gas supply to the
dryer at 12.5 ± 1.5" W.C. (31.8 ± 3.8cm W .C.)
Use a "U" tube manometer (or similar pressure
gauge) to check the pressure.
Installation Instructions
1. Disconnect the electrical power
to the dryer.
2. Shut off the gas supply to the dryer.
3. Remove the louvered vent panel
on the rear of the dryer. Disengage the
drum belt by rotating the idler pulley
down and away from the motor. Slide
the belt off of the pulleys. (Figure 1)
4. Use a thin flat head screwdriver to disengage
the spring clips under the top cover.(Figure 2)
Figure 1
- 17 -
Issue
Rev.
Regulator Blocking Plug
Main Burner Orifice
Motor Pulley
Drum Belt
Idler Pulley
Figure 2